2011-02 | Reliability-based topology optimization using a standard response surface method for three-dimensional structures | 한석영 |
2011-02 | Numerical analysis of gaseous hydrogen/liquid oxygen flamelet at supercritical pressures | 김용모 |
2011-02 | DEFLECTION TEST AND TRANSMISSION ERROR MEASUREMENT TO IDENTIFY HYPOID GEAR WHINE NOISE | 오재응 |
2011-02 | Influence of ethanol blends on the combustion performance and exhaust emission characteristics of a four-cylinder diesel engine at various engine loads and injection timings | 이창식 |
2011-02 | Cu(In,Ga)Se(2) Thin Film Preparation from a Cu(In,Ga) Metallic Alloy and Se Nanoparticles by an Intense Pulsed Light Technique | 김학성 |
2011-04 | Correlations and optimization of a heat exchanger with offset-strip fins | 이관수 |
2011-04 | Development of a New Magnetizing Fixture for the Permanent Magnet Brushless DC Motors to Reduce the Cogging torque | 장건희 |
2016-03 | Two-step flash light sintering process for enhanced adhesion between copper complex ion/silane ink and a flexible substrate | 김학성 |
2016-03 | Combustion performance, flame, and soot characteristics of gasoline-diesel pre-blended fuel in an optical compression-ignition engine | 박성욱 |
2016-03 | Effect of multiple injection strategies on combustion and emissions characteristics in a diesel engine | 이창식 |
2016-03 | Microscopic observation of frost behaviors at the early stage of frost formation on hydrophobic surfaces | 김동립 |
2011-03 | Corrosion fatigue crack propagation in a heat affected zone of high-performance steel in an underwater sea environment | 김태원 |
2011-03 | Measurements of dynamic properties of concrete structures using flexural wave propagation characteristics | 박준홍 |
2011-03 | 이점 대각 이차 근사화 기법을 쌍대기법에 적용한 순차적 근사 최적설계 | 최동훈 |
2011-03 | The characteristics of bio-oil produced from the pyrolysis of three marine macroalgae | 박준홍 |
2011-03 | A study of spray strategies on improvement of engine performance and emissions reduction characteristics in a DME fueled diesel engine | 이관수 |
2011-03 | A study of spray strategies on improvement of engine performance and emissions reduction characteristics in a DME fueled diesel engine | 이창식 |
2011-03 | A study of spray strategies on improvement of engine performance and emissions reduction characteristics in a DME fueled diesel engine | 이창식 |
2011-03 | Pressure loss of gaseous flow at a micro-tube outlet | 이재헌 |
2011-03 | Fatigue crack growth behavior of the simulated HAZ of 800 MPa grade high-performance steel | 김태원 |