Controlled manipulation of CNTs in glass/epoxy composites with cut-outs using non-uniform electric field

Abstract

In this work, an effective methodology to incorporate aligned carbon nanotubes (CNTs) in long fiber composites in the presence of geometric discontinuities has been studied. Unidirectional (UD) glass/CNT-epoxy composites containing circular cut-outs were used as representative of a common discontinuity. Multi-walled (MW) CNTs were introduced in the composites via the epoxy matrix and aligned using low-frequency non-uniform AC electric field. This work discusses the methodology to control CNT alignment around the cut-out with the objective of enhancing the stiffness locally. The effectiveness of CNT alignment was assessed indirectly through the mapping of electrical resistance and polarized Raman spectroscopy. A strong correlation was found between the targeted CNT alignment state and the measured resistance values around the cut-out. As a precursor to developing glass/CNT-epoxy hierarchical composites, the response of MW-CNTs in the epoxy resin system was assessed at various input voltage levels in correlation with the weight fraction (wt.%) of CNTs. While a change in electrical resistance by similar to 3 orders of magnitude was found along the direction of CNT alignment in the hierarchical composites, a change in electrical resistance by similar to 5 orders of magnitude was observed in the CNT-epoxy composites in comparison with that of the respective control samples.