Full metadata record
DC Field | Value | Language |
---|---|---|
dc.contributor.author | 정진태 | - |
dc.date.accessioned | 2020-01-22T02:31:00Z | - |
dc.date.available | 2020-01-22T02:31:00Z | - |
dc.date.issued | 2019-11 | - |
dc.identifier.citation | JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY, v. 33, No. 11, Page. 5589-5602 | en_US |
dc.identifier.issn | 1738-494X | - |
dc.identifier.issn | 1976-3824 | - |
dc.identifier.uri | https://link.springer.com/article/10.1007%2Fs12206-019-1052-0 | - |
dc.identifier.uri | https://repository.hanyang.ac.kr/handle/20.500.11754/122176 | - |
dc.description.abstract | This paper presents a simulation model to predict the percussive drilling performance of a down-the-hole (DTH) hammer. First, the pneumatic dynamic model of the DTH hammer is developed considering mass flow rate relations representing orifice opening areas of the air tube, the piston, and the bit flushing channels. Next, the performance of the DTH hammer is numerically simulated and evaluated by considering fluctuations of the upper and lower chamber pressure, impact frequency, and force. The simulation model is validated through a series of laboratory tests. Finally, design factors influencing the hammers impact performance are selected via screening design, and the progressive quadratic response surface method then optimizes the set of design factors to propose a design modification to increasing the impact performance of the DTH hammer. | en_US |
dc.description.sponsorship | This work was supported by Korea Institute of Industrial Technology (KITECH), South Korea. | en_US |
dc.language.iso | en_US | en_US |
dc.publisher | KOREAN SOC MECHANICAL ENGINEERS | en_US |
dc.subject | Down-the-hole drilling | en_US |
dc.subject | Down-the-hole hammer | en_US |
dc.subject | Percussive rock drilling | en_US |
dc.subject | Impact performance | en_US |
dc.subject | Screening design method | en_US |
dc.subject | Progressive quadratic response surface method (PQRSM) | en_US |
dc.title | design study of impact performance of a DTH hammer using PQRSM and numerical simulation | en_US |
dc.type | Article | en_US |
dc.relation.no | 11 | - |
dc.relation.volume | 33 | - |
dc.identifier.doi | 10.1007/s12206-019-1052-0 | - |
dc.relation.page | 5589-5602 | - |
dc.relation.journal | JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY | - |
dc.contributor.googleauthor | Kim, Dae-Ji | - |
dc.contributor.googleauthor | Oh, Joo-Young | - |
dc.contributor.googleauthor | Cho, Jung-Woo | - |
dc.contributor.googleauthor | Kim, Jaewon | - |
dc.contributor.googleauthor | Chung, Jintai | - |
dc.contributor.googleauthor | Song, Changheon | - |
dc.relation.code | 2019038817 | - |
dc.sector.campus | E | - |
dc.sector.daehak | COLLEGE OF ENGINEERING SCIENCES[E] | - |
dc.sector.department | DEPARTMENT OF MECHANICAL ENGINEERING | - |
dc.identifier.pid | jchung | - |
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.