Ruthenium CMP에서 Cerium Ammonium Nitrate와알루미나 연마 입자가 연마 거동에 미치는 영향
- Title
- Ruthenium CMP에서 Cerium Ammonium Nitrate와알루미나 연마 입자가 연마 거동에 미치는 영향
- Other Titles
- Effect of Cerium Ammonium Nitrate and Alumina Abrasive Particles onPolishing Behavior in Ruthenium Chemical Mechanical Planarization
- Author
- 박진구
- Keywords
- Ru CMP; Noble metal CMP; CAN; Etch rate
- Issue Date
- 2005-09
- Publisher
- 한국전기전자재료학회
- Citation
- 전기전자재료학회논문지, v. 18, NO. 9, Page. 803-809
- Abstract
- Cerium ammonium nitrate (CAN) and nitric acid was used an etchant and an additive for Ru etching and polishing. pH and Eh values of the CAN and nitric acid added chemical solution satisfied the Ru etching condition. The etch rate increased linearly as the concentration of CAN increased. Nitric acid added solution had the high etch rate. But micro roughness of etched surfaces was not changed before and after etching. The removal rate of Ru film was the highest in 1 wt% abrasive added slurry, and not increased despite the concentration of alumina abrasive increased to 5 wt%. Even Ru film was polished by only CAN solution due to the friction. The highest removal rate of 120 nm/min was obtained in 1 M nitric acid and 1 wt% alumina abrasive particles added slurry. The lowest micro roughness value was observed in this slurry after polishing. From the XPS analysis of etched Ru surface, oxide layer was founded on the etched Ru surface. Therefore, Ru was polished by chemical etching of CAN solution and oxide layer abrasion by abrasive particles. From the result of removal rate without abrasive particle, the etching of CAN solution is more dominant to the Ru CMP.
- URI
- http://koreascience.or.kr/article/JAKO200504840655812.pagehttps://repository.hanyang.ac.kr/handle/20.500.11754/181309
- ISSN
- 1226-7945;2288-3258
- Appears in Collections:
- COLLEGE OF ENGINEERING SCIENCES[E](공학대학) > MATERIALS SCIENCE AND CHEMICAL ENGINEERING(재료화학공학과) > Articles
- Files in This Item:
There are no files associated with this item.
- Export
- RIS (EndNote)
- XLS (Excel)
- XML