Compensation of Sensor Gain Difference in Measuring Straightness Errors Using a Mixed Sequential Two-Probe Method
- Title
- Compensation of Sensor Gain Difference in Measuring Straightness Errors Using a Mixed Sequential Two-Probe Method
- Author
- 정성종
- Keywords
- Compensation method; Mixed sequential two-probe method; Sensor gain error; Straightness error
- Issue Date
- 2019-03
- Publisher
- KOREAN SOC PRECISION ENG
- Citation
- INTERNATIONAL JOURNAL OF PRECISION ENGINEERING AND MANUFACTURING, v. 20, NO 3, Page. 427-435
- Abstract
- We present a compensation method for the sensor gain difference when a mixed sequential two-probe method (MTPM) is applied for precision measurements of straightness error. According to theoretical analysis of the effect of sensor gain error, much of the measurement error comes from the sensor gain difference. Also, measurement error caused by misalignment of the straight-edge is dramatically amplified by the sensor gain difference. Therefore, the measurement error in MTPM can be significantly reduced by compensating for the sensor gain difference. To compensate for sensor gain difference, we propose a very simple approach that uses sensor outputs for two different alignment conditions of the straight-edge. To verify the proposed compensation method, experiments were performed with a hydrostatic linear motion table. Experimental results show that the gain difference of the two sensors used in the experiments was about 3.4%. Before compensation, the deviation in the calculated straightness error depending on the alignment conditions was 1.30m, which was reduced to 0.08m after compensation. The compensated measurement results were compared with results obtained by a reversal method. The maximum deviation between the two methods was 0.22m. These results demonstrate that the proposed compensation method is very effective for the measurement of straightness error with sub-micron accuracy and in addition it is practical because compensation can be performed on the actual measurement setup.
- URI
- https://link.springer.com/article/10.1007%2Fs12541-019-00063-7https://repository.hanyang.ac.kr/handle/20.500.11754/109932
- ISSN
- 2234-7593; 2005-4602
- DOI
- 10.1007/s12541-019-00063-7
- Appears in Collections:
- COLLEGE OF ENGINEERING[S](공과대학) > MECHANICAL ENGINEERING(기계공학부) > Articles
- Files in This Item:
There are no files associated with this item.
- Export
- RIS (EndNote)
- XLS (Excel)
- XML