Full metadata record
DC Field | Value | Language |
---|---|---|
dc.contributor.author | Megumi Kawasaki | - |
dc.date.accessioned | 2018-03-09T05:30:49Z | - |
dc.date.available | 2018-03-09T05:30:49Z | - |
dc.date.issued | 2013-07 | - |
dc.identifier.citation | JOURNAL OF MATERIALS SCIENCE 권: 48 호: 13 페이지: 4653-4660 | en_US |
dc.identifier.issn | 0022-2461 | - |
dc.identifier.uri | http://dx.doi.org/10.1007/s10853-012-7072-0 | - |
dc.identifier.uri | http://hdl.handle.net/20.500.11754/44182 | - |
dc.description | European Research Council under ERC | en_US |
dc.description.abstract | Experiments were conducted to evaluate the microstructures and mechanical properties of a Cu-0.1 % Zr alloy processed using two different techniques of severe plastic deformation: equal-channel angular pressing (ECAP) and high-pressure torsion (HPT). The samples were processed at room temperature through ECAP for eight passes or through HPT for 10 turns. The results show HPT is more effective both in refining the grains and in producing a large fraction of grain boundaries having high angles of misorientation. Both procedures produce reasonably homogeneous hardness distributions but the average hardness values were higher after HPT. In tensile testing at 673 K, the highest strength and ductility was achieved after processing by HPT. This is attributed to the grain stability and high fraction of high-angle grain boundaries produced in HPT. | en_US |
dc.description.sponsorship | National Science Foundation of the United States | en_US |
dc.language.iso | en | en_US |
dc.publisher | SPRINGER, 233 SPRING ST, NEW YORK, NY 10013 USA | en_US |
dc.subject | HIGH-PRESSURE TORSION | en_US |
dc.subject | SEVERE PLASTIC-DEFORMATION | en_US |
dc.subject | GRAIN-REFINEMENT | en_US |
dc.subject | ALUMINUM-ALLOY | en_US |
dc.subject | SUPERPLASTIC DUCTILITIES | en_US |
dc.subject | EVOLUTION | en_US |
dc.subject | HOMOGENEITY | en_US |
dc.subject | ECAP | en_US |
dc.subject | MG | en_US |
dc.subject | COPPER | en_US |
dc.title | A comparison of microstructures and mechanical properties in a Cu-Zr alloy processed using different SPD techniques | en_US |
dc.type | Article | en_US |
dc.relation.volume | 48 | - |
dc.identifier.doi | 10.1007/s10853-012-7072-0 | - |
dc.relation.page | 4653-4660 | - |
dc.relation.journal | JOURNAL OF MATERIALS SCIENCE | - |
dc.contributor.googleauthor | Wongsa-Ngam, Jittraporn | - |
dc.contributor.googleauthor | Kawasaki, Megumi | - |
dc.contributor.googleauthor | Langdon, Terence G. | - |
dc.relation.code | 2013010787 | - |
dc.sector.campus | S | - |
dc.sector.daehak | COLLEGE OF ENGINEERING[S] | - |
dc.sector.department | DIVISION OF MATERIALS SCIENCE AND ENGINEERING | - |
dc.identifier.pid | megumi | - |
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.