2016-08 | Damage analysis of CMOS electro-optical imaging system by a continuous wave laser | 장경영 |
2021-02 | Decoupled Longitudinal and Lateral Vehicle Control Based Autonomous Lane Change System Adaptable to Driving Surroundings | 장경영 |
2021-02 | Deep Learning-Based Ultrasonic Testing to Evaluate the Porosity of Additively Manufactured Parts with Rough Surfaces | 장경영 |
2015-06 | Demonstration of Disturbance Propagation and Amplification in Car-following Situation for Enhancement of Vehicle Platoon System | 장경영 |
2018-01 | Dependence of nonlinear ultrasonic characteristic on second-phase precipitation in heat-treated Al 6061-T6 alloy | 장경영 |
2015-12 | Determination of Laser Beam Intensity to Maximize Amplitude of Ultrasound Generated in Ablation Regime via Monitoring Plasma-induced Air-borne Sound | 장경영 |
2018-11 | Evaluation of quadratic nonlinearity in tensile curve from ultrasonic linear and nonlinear measurements | 장경영 |
2012-04 | Evaluation of Subsurface Defects in Fiber Glass Composite Plate using Lock-in Technique | 장경영 |
2013-05 | Evaluation of Ultrasonic Nonlinear Characteristics in Heat-Treated Aluminum Alloy | 장경영 |
2013-10 | Evaluation of Ultrasonic Nonlinear Characteristics in Heat-Treated Aluminum Alloy (Al-Mg-Si-Cu) | 장경영 |
2020-06 | Evaluation of yield strength by ultrasonic reconstruction of quadratic nonlinear Stress-Strain curve | 장경영 |
2016-02 | Experimental Comparison of Nonlinear Parameters Obtained from Absolute Measurement and Relative Measurement | 장경영 |
2015-11 | Experimental Comparison of Ultrasonic Nonlinearity Measured by PZT and LiNbO3 Transducers | 장경영 |
2015-11 | Experimental investigation of CW laser-induced ignition on CFRP | 장경영 |
2021-06 | Experimental Verification of Contact Acoustic Nonlinearity at Rough Contact Interfaces | 장경영 |
2012-05 | Fatigue-Induced Micro-damage Characterization of Austenitic Stainless Steel 316 Using Innovative Nonlinear Acoustics | 장경영 |
2013-06 | Feasibility of MFC(Macro-Fiber Composite) Transducers for Guided Wave Technique | 장경영 |
2017-01 | Finite element analysis of a low-velocity impact test for glass fiber-reinforced polypropylene composites considering mixed-mode interlaminar fracture toughness | 장경영 |
2012-08 | Frequency Characteristics of Surface Wave Generated by Single-Line Pulsed Laser Beam with Two Kinds ofSpatial Energy Profile Models: Gaussian and Square-Like | 장경영 |
2012-01 | Frequency Response of Narrowband Surface Waves Generated by Laser Beams Spatially Modulated with a Line-arrayed Slit Mask | 장경영 |
2012-05 | Harmonic generation of an obliquely incident ultrasonic wave in solid-solid contact interfaces | 장경영 |
2019-06 | Imaging and Sizing of Surface Defects Using Synthetic Aperture Focusing of Laser-generated Surface Waves | 장경영 |
2013-07 | Imaging of contact acoustic nonlinearity using synthetic aperture technique | 장경영 |
2014-11 | Improvement of Crack Sizing Performance by using Nonlinear Ultrasonic Technique | 장경영 |
2014-07 | In situ detection of laser-induced slip initiation on the silicon wafer surface | 장경영 |
2014-08 | In-Line Ultrasonic Monitoring for Sediments Stuck on Inner Wall of a Polyvinyl Chloride Pipe | 장경영 |
2020-09 | Indirect Method for Measuring Absolute Acoustic Nonlinearity Parameter Using Surface Acoustic Waves with a Fully Non-Contact Laser-Ultrasonic Technique | 장경영 |
2015-01 | Influence of repetitive pulsed laser irradiation on the surface characteristics of an aluminum alloy in the melting regime | 장경영 |
2013-07 | Influence of slit width on harmonic generation in ultrasonic surface waves excited by masking a laser beam with a line arrayed slit | 장경영 |
2013-06 | Initial Second Harmonic Generation in Narrowband Surface Waves by Multi-Line Laser Beams for Two Kinds of Spatial Energy Profile Models: Gaussian and Square-Like | 장경영 |